Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Sweep Across White City
Most people in White City don’t think they have a chimney. Then a technician points at the metal flue rising through the utility room roof and explains that the thing venting their gas water heater or dryer is, in fact, a chimney, and one that needs attention. White City sits just west of Fort Pierce along the Okeechobee Road corridor, and the housing here tells the story of South Florida: single-story concrete-block ranchers, carports, and appliance vents running long paths to the outside. We know that layout, and we know how White City homes are built and vented. Call (844) 990-3838 to book a sweep or an inspection. We answer 24/7.

Why White City Homeowners Call Unity Chimney Sweep for Chimney Sweep
What sets our work apart in White City is the order we do things. We inspect before we sweep, and repair what we find. A camera goes into the flue, and you see the same footage we do. If a clay-tile liner has one cracked tile, we can talk about a spot repair or a HeatShield resurfacing rather than jumping straight to a full reline. That matters in White City, where older block homes have flues that were often never lined at all.
Our technicians have up to 11 years of experience, and every visit runs through the full chimney care sequence: sweep, inspection, and any repair, all under one company. No handoffs to a second contractor who shows up weeks later. Residents around Midway Road and the Okeechobee Road stretch get the same protocol as anyone else in the area.
You don’t need a fire in the firebox to need us. A clothes dryer that takes two cycles to dry a load or a gas appliance that soots or backdrafts is a venting problem, and that’s the kind of call we take most often in this part of the Treasure Coast. Call (844) 990-3838 to set it up. We answer 24/7.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Gas Fireplace Cleaning in White City
Gas Fireplace Cleaning in White City usually means something different than it does up north: many of the decorative fireplaces in 1980s and 1990s ranch homes here burn gas, so the work is about the vent and the burn, not ash and creosote. A typical gas fireplace cleaning in White City runs $140 to $260. The technician checks the flue for soot and debris, confirms the vent terminates correctly, and looks at the burner for corrosion or clogging. If the fireplace hasn’t run in a season or two, or the flame looks lazy and yellow, that’s the cue.
What the Vent Check Covers
A gas fireplace vent can be sealed by a bird nest, a wasp nest, or rust at a joint, all of which are common year-round in South Florida’s humidity. The camera shows us what’s actually inside the run, so we can clear it or flag a repair without guessing.
When to Call for Gas Fireplace Cleaning
If you smell gas, get a soot film on the glass or logs, or the appliance backdrafts when it’s running, stop using it and call. Your gas service handles the gas line; we handle the vent and the appliance flue. Call (844) 990-3838 for an exact quote. Estimates are free.
Chimney Maintenance in White City
Chimney Maintenance in White City is mostly about keeping venting clear and cap-and-cover weatherproofing intact, because subtropical heat and humidity mean slow creosote but fast failure of metal and seals. A typical maintenance visit here runs $120 to $180, and includes a check of the vent, the cap, the flashing, and any masonry or chase the home has. Because chimneys here rarely see heavy heating use, a once-a-year look is usually enough unless there’s an appliance venting issue.
The Annual Look Matters More Than the Sweep
We inspect before we sweep, so the annual visit is where we catch a rusting B-vent joint or a missing cap before it becomes a ceiling stain. Wind-driven rain during hurricane season drives water into any uncapped flue, so a cap is one of the higher-value fixes we make here. Gelco and Famco caps and covers are spec-grade, not hardware-store pieces.
What a Maintenance Visit Covers
A maintenance visit checks caps, flashing, mortar joints, and vent terminations. We tell you what your chimney actually needs, not what adds the most to an invoice; if a chase is sound and the cap is intact, we’ll say so. Call (844) 990-3838. We answer 24/7.

Trusted Brands We Service in White City
We source and install products from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield, which lets us match the repair to the flue rather than reaching for whatever’s on the shelf. HeatShield lets us resurface a damaged flue from the inside; DuraFlex handles liner replacement when a flue is too far gone for resurfacing. Gelco and Famco cover the cap-and-cover category. These aren’t exclusive partnerships, just the brands we work with because the components hold up in South Florida. We don’t claim to stock parts locally or run a fleet, but we can specify and install what the job needs without a second vendor. One company, every part of the chimney.
Common Chimney Sweep Problems We See in White City Homes
- Unlined or cracked clay flues: Older block homes here often have clay-tile or bare flues that show spalling mortar and cracks. Without camera evidence, that becomes an easy pitch for a full reline; with it, you can often see whether a spot repair is enough.
- Rusted B-vent joints: The metal appliance flues common in White City block homes rust through at seams in the humidity. The leak is invisible from the ground until a water stain shows up on the ceiling.
- Sealed-over fireplace chases: Remodelers on older Midway Road homes sometimes sealed a fireplace without removing the flue, leaving an uncapped, unlined stack that still lets rain in and birds nest. No firebox is visible, so the problem is missed.
- Lint in long dryer runs: Dryer vents running long, awkward paths through carports and utility rooms accumulate lint that simple rodding misses. That’s a fire risk the homeowner believes was cleaned.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Sweep in White City, FL
A typical chimney sweep in White City runs $140 to $260, and a Level 2 inspection with camera runs $220 to $420. Creosote removal, if it requires chemical treatment for glazed third-degree buildup, adds to the sweep price and depends on the extent. Soot removal on appliance flues is typically folded into the sweep. Maintenance visits generally fall between $120 and $180. What moves the number is access to the vent, whether the flue is accessible from the roof, and whether the run needs repair. The written estimate sets the final price, and it’s free. Call (844) 990-3838 to book. Fast dispatch from 7am to 7pm, Sunday through Friday.
We Also Serve Cities Near White City
White City sits in the middle of the Treasure Coast, and we regularly serve the communities around it, including Indian River Estates, Fort Pierce South, Fort Pierce, and Fort Pierce North. If you’re just outside the White City line, or along the Okeechobee Road corridor toward Fort Pierce, our White City service area covers you. Call (844) 990-3838 to confirm.
Serving White City, FL – Our Local Coverage Area
We serve White City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Sweep in White City
Because in White City, “chimney” almost always means the appliance flue, not a firebox. Gas water heaters, furnaces, and dryers vent through metal flues or B-vents, and those runs collect lint, bird nests, and rust just like a wood chimney collects creosote. Call (844) 990-3838 to book an inspection.
A Level 2 inspection with camera typically runs $220 to $420 in White City. The technician looks inside the flue with a camera, checks the cap, flashing, and mortar joints, and confirms the vent terminates correctly. You see the footage. Call (844) 990-3838 for an exact quote.
Yes. When a remodeler sealed the chase without removing the flue, the stack is still there, still uncapped, and still drawing in rain and nesting birds. It may also be unlined. A camera inspection tells you what’s actually inside. Call (844) 990-3838 to set one up.
Once a year is a reasonable schedule for most White City homes, or sooner if a dryer is taking multiple cycles or a gas appliance is sooting or backdrafting. Lint and nests build up year-round here, and rust at a B-vent joint can happen before it’s visible. Call (844) 990-3838.
Soot on the logs or glass, a lazy yellow flame, backdraft into the room, or a fireplace that hasn’t run in a season are the usual signs. Any gas smell, stop using it and call your gas service. For the vent and flue, call (844) 990-3838. We answer 24/7; a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Book Your White City Chimney Sweep
If you’ve never had your appliance flue or capped chase looked at, that’s the place to start. We inspect before we sweep, show you the camera footage, and repair only what the evidence supports, so you’re not talked into a reline you can’t verify. Pricing is set per job by the written estimate. Call (844) 990-3838 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Unity Chimney Sweep.